Antec Sonata IV-620 Manual do Utilizador descarregar pdf (Página 7)

2.4 Internal 3.5” Device Installation

This case offers a unique hard disk mounting system. There are two dedicated

hard disk compartments right under the external 5.25” drive cage. Each

compartment can hold two hard disk drives.

1. Open the side panel as described in Setting Up. You will find four metal

mounting rails with soft silicone grommets preinstalled inside each of the

HDD compartments. Each drive rail is fastened inside the compartment

with a thumb screw. You will need two mounting rails to mount a HDD. One

rail is fastened to the upper wall of the compartment and the

other rail is fastened to the lower wall of the compartment.

2. Remove both the upper and the lower mounting rails by

loosening the thumb screws.

3. Fasten the rails to the sides of the HDD through the silicone

grommets with the special screws provided.

Note:

Don’t over-tighten. Over-tightening the screws will harm the

vibration and noise reduction qualities of the silicone grommets.

4. Slide the HDD assembly into the compartment.

5. The connectors of the drive must face the left side panel (away

from the intake vent).

6. Use the thumb screws to fasten the HDD assembly into the

case.

7. Find the appropriate power connector on the PSU and connect

the device.

8. Find the appropriate data cable and connect the hard drive to

the motherboard.

2.5

External 3.5” Device Installation

To install a floppy drive, card reader or other external 3.5” device using the 5.25” to 3.5”

adapter:

1. Locate the 5.25” to 3.5” adapter bracket.

2. Place the device in the adapter and fasten with the screws provided.

3. Install the drive rails to the adapter as described in the External 5.25” Device Installation

section.

4. Slide the drive into the drive bay until you hear a click.

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Antec Sonata IV-620 Manual do Utilizador Página 7