Antec SKELETON Manual do Utilizador descarregar pdf (Página 10)

Connecting the Front I/O Ports

3.1 USB 2.0 Ports

Connect the front I/O panel USB cable to the USB header pin on your mother-

board. Check the motherboard manual to ensure that it matches the table below:

Motherboard USB Pin Layout

Locate the internal USB connector on your motherboard and connect the

corresponding cable.

3.2 eSATA Port

Connect the front I/O panel SATA cable to a standard SATA connector on your

motherboard.

3.3 IEEE 1394 Port

Connected to the Skeleton front I/O panel there is an Intel® standard 10-pin

connector. The pin assignments for these connectors are as follows:

Pin Assignment for Front Panel IEEE 1394 Connector

Locate the internal IEEE 1394 connector on your motherboard and connect the

corresponding cable.

Pin Signal Names Pin Signal Names

USB Power 1

USB Power 2

Negative Signal 1

Negative Signal 2

Positive Signal 1

Positive Signal 2

Ground 1

Ground 2

Key (No Connection)

Empty Pin

Pin Signal Names Pin Signal Names

1 TPA+ 2 TPA–

3 Ground 4 Ground

5 TPB+ 6 TPB–

7 +12V (Fused) 8 +12V (Fused)

9 Key (No Pin) 10 Ground

109

1 2 ... 5 6 7 8 9 10 11 12 13 14

Sem comentários

Antec SKELETON Manual do Utilizador Página 10