Antec GX700 Manual do Utilizador descarregar pdf (Página 12)

The GX700 comes with motherboard standoffs (B in section 1.3). These are

meant to be positioned for Standard ATX, microATX or Mini-ITX motherboards and can be relocated to

accommodate various form factors.

1. Lay the case down so that the open side is up.

2. Align the motherboard with the standoff holes on the motherboard tray and remember or mark

which holes are lined up.

3. Install standoffs as needed and put the motherboard in.

4. Screw your motherboard into the standoffs with the provided mounting screws (C in section

1.3).

CAUTION

Make sure to remove any unused motherboard standoffs. They

may come into contact with the back of the motherboard and may

electrify your chassis exterior if left connected.

Install the motherboard standoffs by aligning the motherboard with the

standoff holes.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 24 25

Sem comentários

Antec GX700 Manual do Utilizador Página 12