Antec GX300 Window Manual do Utilizador descarregar pdf (Página 10)

2.1 Setting Up

Put the case upright on a flat, stable surface so that the side panel is

facing you. To remove the left and right side panels, remove these

thumbscrews first.

Note: Place the panel thumbscrews aside carefully and remember

where they are.

Remove the panel by gripping the end of the panel

at the top & bottom and swinging the panel outward.

Do not pull the panel back toward the rear of the chassis.

CAUTION: Do not use your fingernails to pry or lift the panels. Damage to the panels or

injury to your fingernails may result.

2.2 Motherboard Installation

Before proceeding:

Check the manual for your CPU cooler to find out if there are steps you must do before installing the

motherboard.

Make sure you have the correct I/O panel for your motherboard. If the panel provided with the chassis

isn’t suitable, please contact your motherboard manufacturer for the correct I/O panel.

Make sure you have the correct I/O panel.

Remove the panel by the end of the panel at the top & bottom and

swing the panel outward.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Sem comentários

Antec GX300 Window Manual do Utilizador Página 10